Concrete grinder
concrete grinder
Use-BS 180 / BS 280 Concrete grinding machine
Directions for Use:
- Hold and operate the machine always with 2 hands! Never operate with only 1 hand.
- Check the power cord and the plug before starting.
- Have damaged insulation repaired at once, before starting the machine.
- Use faultless blades only! Worn blades give poor results.
- A suitable vacuum cleaner may be connected with the machine.
Press the machine always with 2 hands towards the subfloor. The spring-loaded suction ring limits the pressure of the blade towards the ground and makes suction very efficient.
Changing the blade:
NOTE: Always disconnect the power supply before changing the blade!
Unintended starting of the machine may cause injury, e.g. of your hands.
– Press spindle lock (on top of the machine) and turn the blade until it locks
– Loosen tension screw (1) with the fork wrench (note it is a standard clockwise thread).
– Remove blade
– Press spindle lock and fasten the flange.
NOTE: clean the flange and the blade before refitting the new blade. Dirt may cause vibrations and rough running.
Replacement Blades:
– 7” Single Row Diamond Grinding Disc
– 7” Double Row Diamond Grinding Disc
– 7” Astra Diamond Grinding Disc
– 7” Rigid Carbide Grinding Disc (Med.)
– 7” Rigid Carbide Grinding Disc (Coarse)
Restriction of use
A. The BS 180/BS 280 concrete grinding machine us exclusively for grinding sub floors and removing uneven sections in dry environments. It should not be used for any other purpose. SINCLAIR cannot be held responsible for any damage or loss caused by incorrect use. Correct use also includes:
– to take care of all directions from the operating manual and the execution of maintenance and service.
B. The BS 180/BS 280 concrete grinding machines is designed for EDGING ONLY and is not intended for constant floor grinding. Excessive use of the machine could result in electrical overload and would void the warranty.
[Back to Top]