A139 / A139M - 04(2010)
Abstract
This specification covers five grades of electric-fusion(arc)-welded straight-seam or helical steel pipe including pipe of NPS 4 and over. The required chemical composition, tensile requirements of the steel, and the tensile requirements of the production welds are presented. Heat analysis of each heat of steel was made to determine the percentage of the elements as per chemical requirements. Tests to be performed shall include one longitudinal tension test for the steel, one reduced-section production weld test for the pipe, and hydrostatic test for each length of the pipe.
This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the Standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.
1. Scope
1.1 This specification covers five grades of electric-fusion (arc)-welded straight-seam or helical-seam steel pipe. Pipe of NPS 4 (Note 1) and larger with nominal (average) wall thickness of 1.0 in. [25.4 mm] and less are covered. Listing of standardized dimensions are for reference (Note 2). The grades of steel are pipe mill grades having mechanical properties which differ from Standard plate grades. The pipe is intended for conveying liquid, gas, or vapor.
Note 1—The dimensionless designator NPS (nominal pipe size) has been substituted in this Standard for such traditional terms as “nominal diameter,”“ size,” and “nominal size.”
Note 2—A comprehensive listing of Standardized pipe dimensions is contained in ASME B36.10M.
Note 3—The suitability of pipe for various purposes is somewhat dependent on its dimensions, properties, and conditions of service. For example, for high-temperature service see applicable codes and Specification A691.
1.2 The values stated in either inch-pound units or in SI units are to be regarded separately as Standard. Within the text, the SI units are shown in brackets. The values in each system are not exact equivalents; therefore, each system is to be used independently of the other.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the Standard.
ASTM Standards
A370 Test Methods and Definitions for Mechanical Testing of steel Products
A751 Test Methods, Practices, and Terminology for Chemical Analysis of steel Products
American Welding Society Standard
AWSB2.1 Standard for Welding Procedure and Performance Qualifications Welding Handbook, Vol 1, 8th ed
ASME Standards
ASMEBoilerandPressureVesselCode: Section IX, Welding Qualifications
Index Terms
arc welded steel pipe; fusion welded steel pipe; steel pipe; welded steel pipe; Electric-fusion-welded steel pipe; Gas pressure systems/applications--specifications; Liquid conveyance; Vapor transmission; Welded steel pipe--specifications; ICS Number Code 23.040.10 (Iron and steel pipes)
DOI: 10.1520/A0139_A0139M-04R10
[Back to Top]